CHSGL - URETHANE CATALYST - SEMI-GLOSS/INTERIOR, 340 SG

  • MSDS: CHSGL
  • Manufacturer: CARDINAL INDUSTRIAL FINISHES
  • Product Name: URETHANE CATALYST - SEMI-GLOSS/INTERIOR, 340 SG
  • National Stock Number: 8010-00N027860
Product Identification

Product ID:URETHANE CATALYST - SEMI-GLOSS/INTERIOR, 340 SG
MSDS Date:01/09/1997
FSC:8010
NIIN:00N027860
Status Code:A
MSDS Number: CHSGL

Responsible Party
CARDINAL INDUSTRIAL FINISHES
1329 POTRERO AVE
SOUTH EL MONTE, CA 91733
US

Emergency Phone: 800-424-9300 (CHEMTREC)

Info Phone: 213-283-9335

Preparer: RICHARD A. STEWART

Cage: 65860

Contractor
CARDINAL INDUSTRIAL FINISHES
SOUTH EL MONTE, CA 91733 US

Telephone: 818-444-9274 OR 213-283-9335

Cage: 65860

Ingredients

70 @ 20C.

CAS: 78-93-3

RTECS: EL6475000

Fraction By Weight: 1.49%

OSHA PEL 200 PPM

ACGIH TLV: 200 PPM; 300 STEL

EPA Report Quantity: 5000 LBS

DOT Report Quantity: 5000 LBS


70 @ 20C.

CAS: 141-78-6

RTECS: AH5425000

Fraction By Weight: 6.59%

OSHA PEL 400 PPM

ACGIH TLV: 400 PPM

EPA Report Quantity: 5000 LBS

DOT Report Quantity: 5000 LBS


10 @ 20C.

CAS: 123-86-4

RTECS: AF7350000

Fraction By Weight: 2.44%

OSHA PEL 150 PPM

ACGIH TLV: 150 PPM; 200 STEL

EPA Report Quantity: 5000 LBS

DOT Report Quantity: 5000 LBS


<0.1 @

CAS: 584-84-9

RTECS: CZ6300000

Fraction By Weight: 0.18%

OSHA PEL 0.02 PPM, C

ACGIH TLV: 0.005 PPM; 0.02 STEL

EPA Report Quantity: 100 LBS

DOT Report Quantity: 100 LBS


<0.1 @ 20C.

CAS: 822-06-0

RTECS: MO1740000

Fraction By Weight: 0.20%

OSHA PEL N/K

ACGIH TLV: 0.005 PPM

EPA Report Quantity: 1 LB

DOT Report Quantity: 1 LB


0.95 LB/GAL;

RTECS: 9999999VO

OSHA PEL N/K

ACGIH TLV: N/K


ARE PRESENT. IN LIEU OF AIR MONITORING DATA, NIOSH

RTECS: 9999999ZZ


APPLICATION. OBSERVE OSHA REGS FOR RESP USE (29 CFR

RTECS: 9999999ZZ


SAFETY EQUIP SUPPLIER). PREVENT

RTECS: 9999999ZZ


IMPERVIOUS CLOTHING & CHEMICAL RESISTANT BOOTS.

RTECS: 9999999ZZ

Hazards

LD50 LC50 Mixture:NONE SPECIFIED BY MANUFACTURER.
Routes of Entry: Inhalation:YES Skin:YES Ingestion:NO
Reports of Carcinogenicity:NTP:NO IARC:YES OSHA:NO
Health Hazards Acute and Chronic:EYES: CAN CAUSE IRRITATION AND
REDNESS, TEARING OR BLURRED VISION. SKIN: MODERATE IRRITATION
POSSIBLE FROM PROLONGED EXPOSURE, DEFATTING AND DERMATITIS.
INHALATION: NASAL IRRITATION, HEADACHE, DIZZINE SS, NAUSEA,
WEAKNESS OR VOMITING. LOSS OF CONSCIOUSNESS. INGESTION: GI
IRRITATION, HEADACHE, (EFTS OF OVEREXP)
Explanation of Carcinogenicity:TOLUENE DIISOCYANATE (2,4): IARC
MONOGRAPHS, SUPPLEMENT, VOL 7, PG 56, 1987:GROUP 2B.
Effects of Overexposure:HLTH HAZ: DIZZINESS, NAUSEA, WEAKNESS OR
VOMITING.
Medical Cond Aggravated by Exposure:PRE-EXISTING RESP CNDTNS,
PRE-EXISTING SKIN DISORDERS, LIVER & KIDNEY DISORDERS. ALLERGIC
SKIN OR RESP REACTION MAY OCCUR IN SOME INDIVIDUALS. RESP
SENSITIVITY RSLTS IN ASTHMA-LIKE SYMPS ON (SUPDAT)

First Aid

First Aid:EYES: FLUSH WITH WATER FOR AT LEAST 15 MINUTES. GET MEDICAL
ATTENTION IMMEDIATELY. SKIN: WASH EXPOSED AREA WITH SOAP AND WATER.
REMOVE CONTAMINATED CLOTHING. INHAL: REMOVE TO FRESH AIR. IF
BREATHING I S DIFFICULT, ADMINISTER OXYGEN. IF BREATHING HAS
STOPPED, GIVE ARTIFICIAL RESPIRATION. GET MEDICAL ATTENTION.
INGEST: DO NOT INDUCE VOMITING. KEEP PERSON WARM AND QUIET. GET
MEDICAL ATTENTION.

Fire Fighting

Flash Point Method:TCC
Flash Point:24.0F,-4.4C
Lower Limits:0.9%
Upper Limits:11.4%
Extinguishing Media:FOAM, DRY CHEMICAL, CARBON DIOXIDE, WATER FOG.
Fire Fighting Procedures:USE NIOSH APPROVED SCBA AND FULL PROTECTIVE
EQUIPMENT .
Unusual Fire/Explosion Hazard:CONTAINERS MAY DEFORM OR EXPLODE WHEN
EXPOSED TO EXTREME HEAT. DECOMPOSITION PRODUCTS MAY YIELD OXIDES OF
CARBON AND NITROGEN.

Accidental Release

Spill Release Procedures:REFER TO OTHER SECTIONS IV, V, VI VII & VIII
OF MSDS. ELIMINATE ALL IGNITION SOURCES. ABSORB LIQUID IN ABSORBENT
MATERIAL AND PREVENT SPREADING TO GROUND WATER.
Neutralizing Agent:NONE SPECIFIED BY MANUFACTURER.

Handling

Handling and Storage Precautions:CNTNRS OF THIS MATL MAY BE HAZ WHEN
EMPTIED, SINCE EMPTIED CNTNRS RETAIN PROD RESIDUALS (VAP, LIQ &/OR
SOLID). ALL HAZ PRECS IN MSDS MUST BE OBSERVED.
Other Precautions:PAINT AND SOLVENTS HAVE BEEN LINKED TO LIVER
ABNORMALITIES, KIDNEY AND LUNG DAMAGE. FOR INDUSTRIAL USE ONLY WITH
ADEQUATE VENTILATION. FOLLOW PRECAUTIONS OF MSDS TO PREVENT
OVEREXPOSURE.

Exposure Controls

Respiratory Protection:IF TLV OF PROD OR ANY COMPONENT IS EXCEEDED, A
NIOSH APPRVD AIR SUPPLIED RESP IS ADVISED IN ABSENCE OF
ENVIRONMENTAL CONTROL. OSHA REGS ALSO PERMIT OTHER NIOSH APPRVD
RESPS UNDER SPECIFIED CNDTNS. (SE E SAFETY EQUIP SUPPLIER.)
(SUPDAT)
Ventilation:PROVIDE SUFFICIENT MECH(GEN &/OR LOC EXHST) VENT TO
MAINTAIN EXPOS BELOW TLV(S) &/OR USE NIOSH APPRVD AIR SUPPLIED
RESP.
Protective Gloves:CHEMICAL AND SOLVENT RESISTANT GLOVES.
Eye Protection:ANSI APPRVD CHEM WORKERS GOGGLES .
Other Protective Equipment:ANSI APPROVED EYE WASH & DELUGE SHOWER .
SPLASH ARPONG SUGGESTED FOR MIXING OPERATIONS (CONSULT YOUR (ING 9)
Work Hygienic Practices:"WASH HANDS BEFORE EATING OR USING RESTROOM.
SMOKE IN SMOKING AREAS ONLY."
Supplemental Safety and Health
% VOLAT: 10.7 (WT). MED CNDTNS: SUBSEQUENT EXPOS EVEN BELOW TLV. SKIN
SENSITIVITY RSLTS IN ALLERGIC DERM WHICH MAY INCL RASH, ITCHING,
HIVES & SWELLING OF EXTREMITIES. RESP PROT: ENGINEERING OR ADMINI
STRATIVE CONTROLS SHOULD BE IMPLEMENTEDTO REDUCE EXPOS. WHEN
COATING IS CATALYZED, LOW LEVELS OF ISOCYANATES (ING 7)

Chemical Properties

Boiling Pt:B.P. Text:>171F,>77C
Vapor Pres:SEE INGS
Vapor Density:HVR/AIR
Spec Gravity:1.18
Evaporation Rate & Reference:SLOWER THAN ETHER
Appearance and Odor:NONE SPECIFIED BY MANUFACTURER.
Percent Volatiles by Volume:SUPDAT

Stability

Stability Indicator/Materials to Avoid:YES
AVOID CONTAMINATION WITH WATER, ALCOHOLS, AMINES, ALKALIS AND STRONG
OXIDIZING AGENTS.
Stability Condition to Avoid:EXTREME TEMPERATURES AND CONTACT WITH
MOISTURE.
Hazardous Decomposition Products:BY FIRE: CO*2, CO, OXIDES OF NITROGEN,
TRACES OF HCN, TDI.
Conditions to Avoid Polymerization:WILL NOT OCCUR UNDER NORM CNDTNS OF
USE. PROD WILL REACT W/WATER,ALCOHOLS & AMINES GENERATING HEAT &
GASES SUCH AS CO*2.

Disposal

Waste Disposal Methods:DESTROY BY LIQUID INCINERATION IN ACCORDANCE
WITH APPLICABLE FEDERAL, STATE AND LOCAL REGULATIONS. CONTAMINATED
ABSORBENT SHOULD BE INCINERATED OR SENT TO APPROVED LANDFILL IN
ACCORDANCE WITH LOCAL, S TATE AND FEDERAL REGULATIONS.

Disclaimer (provided with this information by the compiling agencies):
This information is formulated for use by elements of the Department
of Defense. The United States of America in no manner whatsoever,
expressly or implied, warrants this information to be accurate and
disclaims all liability for its use. Any person utilizing this
document should seek competent professional advice to verify and
assume responsibility for the suitability of this information to their
particular situation.